I'll try to watch those videos tonight.
Hope everyone had a good holiday!
If you need a set up form, you're welcome to use mine.
Download and print.
Few things to remember when using this or forms like mine.
Fork Height is measured from the top of the lower triple to the center of the axle
Preload is measured starting OUT and turned IN
I have marked it (S-O) to remind you Start Out.
Comp & Rebound are measured starting IN and turned OUT
I have marked it (S-I) to remind you Start In.
On the rear
Shock length is measured center of top bolt to center of bottom bolt
off the bike
Preload is measured as the difference in the height of the spring measured OFF the shock compared to the height of the spring mounted on the shock. Example: The spring sitting on the table alone may measure 157mm then when you mount it you measure and you have it at 145mm. You then have 12mm of preload.
Comp and Rebound are same as above.
Swing LT is measured from the center of the pivot bolt to the center of the rear axle.
How you use this for those who don't know is create a base line. Then you only track the changes that you make.
Here is a quick example to show you what it should look like.