So i've searched all over the forums and havent found a definitive answer to my issue. The fender eliminator i purchased is http://www.cbrheavenusa2.com/2007-20...-LOW_p_10.html
. for my 2007 600rr
-My issue is that i cant get the brake light to work while having a running light.
-I wired my wires per these instructions that came with the kit.
-The ground wires are all green on my bike. So the the black/yellow is actually a green and yellow.
-Here is how i connected my wires. (turn signals and plate light are working perfectly fine)
-#2 is green/yellow. #1 is white/black. #3 is solid green
-The diode is at the intersection of the 3 wires. red seems to be normal and white seems to receive less power( for the running light)
-I am 100% sure #3 is the ground for the tail. My problem is when i connect the the corresponding #1 and #2s, I only have a running light; I have no brake light even when i apply my brakes.
-When i disconnect #2, i still maintain a running light.
-When i connect #2 from the tail to #1 on the bike, i get a constant brake light.
-When i disconnect both #1 and #2 and connect #1 from the tail to #2 on the bike, no power goes to the tail
Is it possible that i have a bad connection for the #2 connector on my bike or is it another issue?
I blew both the primary and spare fuse so i have to wait till the morning to get some more(where can i get some that the same size and amp? i know radioshack sells variety packs, but im not sure if they included these ones) will http://www.walmart.com/ip/Cooper-Bus...Count/20971322