This post contains the instructions on how to install our UniqueMotoLights Mini H1 HID projector kit into your 2007 - 2012 Honda CBR 600RR headlights.
You may use this post as a support forum for installation questions as well, and i will try to answer any questions that may arise.
This install is not difficult at all, just follow these instructions.
I offer professional installation as well, you can send me in your headlights and i will install this kit, add any options you want like angel eyes, dual angle eyes, Audi Style LED Strips, On/Off switch etc... and will return your headlight to you completely assembled and plug and play.
Installation starts at only $150 + any additional options you choose.
For more information about the kit or to purchase yours please see this post:
2007 - 2012 Honda CBR 600RR Projector headlights kit HID BiXenon Angel Eyes Halo
My website to order is:
This How-to is still work in progress, so i will be periodically adding new info.
* When i say Right or Left headlight its always from the point of view while sitting on the bike *
Lets start with the angel eyes;
For single angel eyes set you will receive two 83mm rings and 2 inverters, you will need to glue the angel eyes to the projector shrouds, using clear Silicone.
For Dual angel eyes you will also receive two 95mm rings.
Remove shrouds from projectors, by unscrewing the screws from the rear of the projectors.
Fish wires through the gaps as shown, very important you want the breaks in the angel eyes to be hidden, so for the right headlight place the wires to the right of the middle big hump on the shroud and for the left headlight to the left of the middle hump on the shroud. Find the hump which points up at 12 o'clock.
Apply silicone on the rear of the ring, all around the shroud on the extending humps of the shroud. tape in a few spots and let it dry.
For dual angel eyes, place the 95mm ring over the shroud.
Tape it in a few spots and also apply clear silicone all round on the extending humps of the shroud.
Look at the open headlight, this is the angle you need to tape the angel eyes, so the wires and gaps will be hidden once the lens is on.
If installing Flexible LED strips, simply silicone them facing forward like this:
Put shrouds on the projectors and secure them with the supplied screws.
Now onto the projector install:
I recommend you do this one headlight at a time.
Preheat oven for 10 minutes to 225 degrees.
Place headlight on a towel and put in center of oven with temperature set at 225 degrees for 8 minutes.
put some gloves on, and remove headlight from oven.
Dont waste any time, and dont let the headlight cool down as the glue will harden again.
Using a few flat head screw drivers or a putty knife and a screw driver pry the headlight open.
You might need to reheat the headlight several times until the lens is removed.