Honda CBR 600RR Forum banner

Akra Tail pipe on RR7

2K views 6 replies 4 participants last post by  Certi 
#1 · (Edited)
I have a 2007 600 rr7, and am looking at buying a used akrapovic rear silencer with link pipe, which is for a 2009 600RR

I have been told that the RR7 and 2009 600rr pipe is slightly different, but it can be made to fit.
Does anybody know how big a modification it is to get Akrapovic link pipe for 2009 to fit a RR7?

Thanks
 
#2 ·
Akrapovic

I have a 2007 600 rr7, and am looking at buying a used akrapovic rear silencer with link pipe, which is for a 2008 600RR8.

I have been told that the RR7 and RR8link pipe is slightly different, but it can be made to fit.
Does anybody know how big a modification it is to get Akrapovic link pipe for RR8 to fit a RR7?

Thanks
The 2007 and 2008 CBR600RR models are identical. There are, however, subtle differences between these models and the 09-12. The Akrapovic slip-on and link pipe for the RR7 and RR8 is identical so you should not have a problem.
 
#3 ·
http://www.600rr.net/vb/showthread.php?t=222547&highlight=akrapovic+mid

The link pipe is slightly different length, 2009 is longer by a smidgen.

I have 2007-2008 slip on on my 2012, it fits but the exhaust doesn't stick out as much.

The bracket on the mid pipe that bolt onto the frame will not line up; but I left it off and it's fine.

In your case, I would assume the exhaust will stick out more than intended.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top