Sup,
Well the modding bug hit hard and fast.
Within a week of getting the bike I was already licking my lips at the possibility of getting some new pipes.
Wasn't until a good month later however that my wallet had enough Sir Monash in it before I could start.
Anyway, the following is a record of my dream build for my dream bike. I can't deny, it is my pride and joy, to the point that my gf will prob leave me soon.
Pfft...
Enjoy and remember, I will be happy to answer any questions you have, post any pic you want, lap up any critic that you may provide (ideas welcome).
~Nick
-------
1) Like a Virgin:
So here she is, all sweet and innocent.
Rolled off the floor and back to my house with only 3.2km to the dial.
2) The opposite to virgin…
I finally got a tail tidy for the bike.
Sure it's not the best looking thing ever, but beats the hell out of the stock tongue looking thing my plates attached to...
Didn't take too long to install.
Was somewhat nervous considering it was my first time messing around with the bike, but I like the end result:
Before (ugry):
During:
After:
3) Anderson Stand:
Went to local stealership today, picked up a Anderson rear stand and some frame pegs.
Was expensive as fcuk, but figured it was worth it as about to order a Hyperflo and don't want to be relying on my kickstand during the install...
Well the modding bug hit hard and fast.
Within a week of getting the bike I was already licking my lips at the possibility of getting some new pipes.
Wasn't until a good month later however that my wallet had enough Sir Monash in it before I could start.
Pfft...
Enjoy and remember, I will be happy to answer any questions you have, post any pic you want, lap up any critic that you may provide (ideas welcome).
~Nick
-------
1) Like a Virgin:
So here she is, all sweet and innocent.
Rolled off the floor and back to my house with only 3.2km to the dial.
2) The opposite to virgin…
I finally got a tail tidy for the bike.
Sure it's not the best looking thing ever, but beats the hell out of the stock tongue looking thing my plates attached to...
Didn't take too long to install.
Was somewhat nervous considering it was my first time messing around with the bike, but I like the end result:
Before (ugry):
During:
After:
3) Anderson Stand:
Went to local stealership today, picked up a Anderson rear stand and some frame pegs.
Was expensive as fcuk, but figured it was worth it as about to order a Hyperflo and don't want to be relying on my kickstand during the install...