hi i'm new to this forum and cbr community and just recently purchased an 03 cbr600rr. i was wondering if you can somehow fit the 07 r6 tail light onto the cbr with a little bit of customize, (note: my exhaust was relocate to lower right side) .
I think you'd need to do some bodywork, possibly fiberglass molds in order to fit any r6 taillight on there, then you could figure out mounting it. You should do some chrome and extend the swing arm on that thing, it would look even nicer!
__________________ Your random animal facts expert.
Damn that thing is low, I was wondering what's off about it.
Get a new rear tire first. As for the taillight, anything is possible with the right craftsmanship but it would look weird as the r6 is sharp and pointy where the rr is round. If you wanna customize might as well dive into the deep end and do a full r6 tail/subframe conversion.