Honda CBR 600RR Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
hey guys new to the rr.net....So im building a go kart with a cbr motor. I completely redid my wiring to favor the kart. I made it key-less with the diode in place and took off all the wiring for the lights and just as i was ready to tape everything up and finish my stainless exhaust system is saw the wires from my emissions system hanging so i decided to just take them out if the system being as they weren't connected to anything. but now its not excepting throttle it cuts out and jumps back. it throws codes naturally for tps and ect sensor. i also have my clutch,bas, and kick stand switch bypassed. i have tried back tracing to a potential problem but haven't found anything. i have the manual that i have been using the wiring diagram extensively and cant find any thing oh and the fan stays on all the time, but when i ground out the green and orange wire from the tps it will except throttle (so this tells me the tps still works) but it cuts the fan or it will run the fan and cut the tps. any wiring gurus out their. essentially I have made a race harness so to say just keeping essentials. this has got me going crazy. i know i'm a bit young but i am smart so any advanced info will be taken accordingly thanks for any help, this is got me going crazy! :retard:
 
1 - 1 of 1 Posts
Top