Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I cut off the tip of the muffler. I used a drill and a 14 inch drill bit. I drilled about 6 holes when I punched it through to make one big hole. Sounds okay, not too impressed. Any thoughts?
 

·
Sweeper Warrior
Joined
·
1,442 Posts
I cut off the tip of the muffler. I used a drill and a 14 inch drill bit. I drilled about 6 holes when I punched it through to make one big hole. Sounds okay, not too impressed. Any thoughts?

here's a thought; post this in the correct section?

just bust'n your ball's mang. might just find another stock can and start over. then you can cut the one your not going to use open to come up with some idea's. then when you figure out what to do as far as eliminating the baffeling, you can do it to the new can and have a shop weld it back together.

i looked around for a stock can, and a lot of people here were willing to just give it to me, or sell it for 10-20$ if i paid shipping. good luck, let us know what you come up with. T.K.
 
1 - 4 of 4 Posts
Top