Honda CBR 600RR Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
231 Posts
Discussion Starter #1
I had a little off recently on track. I'm fine, don't panic.

Bike slid and then rolled probably just the once. Subframe bent, handle bar bent, footpeg and crash bung ground down, bodywork ready for the bin!

It was only about 40mph tops get off, as only in second gear transitioning from one side of track to the other for next corner.

Bike runs fine, all lights light up on dash, however the rev counter needle is stuck at 2,000rpm. It doesn't do it's start up swoosh and doesn't move when you rev the motor.

Any ideas what the problem is?
 
1 - 1 of 1 Posts
Top