Honda CBR 600RR Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hello everyone,

I bought a new set of swingarm spools for my bike but I've been unable to install them yet. The reason is because it seems that the factory swingarm bosses (R-side only) on all 2016CBR's were malpositioned-- not paralleled/aligned with the swingarm itself. Therefore, I cannot screw in my new R-swingarm spool all the way through.

Do I just go and buy a regular washer and call it good, or should I try a different solution?

Your advise will be greatly appreciated!
Please see attachments.

Regards,
Francisco
 

Attachments

·
Registered
Joined
·
59 Posts
huh. my '17 has Vortex spools on it and they fit perfectly. I had no idea of any problems at all.
 

·
Registered
Joined
·
59 Posts
oh just the '16 model specifically?? I was under the impression that the 13+ models were all identical except for colour schemes
 
1 - 7 of 7 Posts
Top