Honda CBR 600RR Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
340 Posts
Discussion Starter · #1 ·
is there a way to retain the stock exhaust/heatshield when replacing your stock rearsets? the stockers (brakeside) has a provision that secures the heatshield in place.

any opinions would be greatly appreciated.
 

·
Hooked on Phonics
Joined
·
2,826 Posts
sorry i have vortex rear sets and i had tryed every thing to put it back on and couldnt figure it out......my recomendation is to go to your local auto store and get some exhaust wrap and wrap your mid pipe i did that and it helps a little
 

·
Not right now chief, im in the f'ing zone
Joined
·
4,495 Posts
Just take it off, you dont need it. Plus it looks sick without it

 

·
Registered
Joined
·
1,432 Posts
Hmm..I have vortexs' too and I'm still running my heat shield..Haha maybe I better take a closer look at it before it falls off..
 

·
Registered
Joined
·
176 Posts
I'm pretty sure it's possible. I have Vortex Rearsets on mine and I think the heat shield is still on there. PM Nutz and ask him.
 

·
Registered
Joined
·
340 Posts
Discussion Starter · #6 ·
cool. im looking to pick up the Vortex. had them on my 636 and were great. i want to keep the stock exhaust and heatshielding if possible.
 
1 - 6 of 6 Posts
Top