Honda CBR 600RR Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter · #1 ·
Any quick tips for removing both 32 pin connectors when changing the air filter. I gave it a quick try before I went into work and had problems with the clips.
 

·
Registered
Joined
·
1,093 Posts
The connectors to the ECU? They have a kind of lever-action clip... just flip that lever up and it releases the connector. Sorry, I don't have any pics, but you should be able to see what I'm talking about.
 

·
fast03600rr
Joined
·
9,995 Posts
i didnt take it off when i put in my filter. just lifted up the airbox lid and worked around it. i'm sure it would be easier with it off but i didnt want to go throught trouble.
 
G

·
the ECU has a set of levers that lift up pushing the connector out. when you put them back in, all you need to do is set the connectors in, and push the levers back down.
 

·
Registered
Joined
·
1,093 Posts
fast03600rr said:
i didnt take it off when i put in my filter. just lifted up the airbox lid and worked around it. i'm sure it would be easier with it off but i didnt want to go throught trouble.
It was probably more trouble to work around it... it takes like 2 seconds to disconnect.
 

·
Registered
Joined
·
105 Posts
Discussion Starter · #6 ·
Sounds easy.. Thanx for the help. I'll give it a shot in the AM.
 

·
Registered
Joined
·
105 Posts
Discussion Starter · #7 ·
Damn, was that filter toast. What an improvement now. More power, less engine noise. And I thought I needed a 07.. Ha
 
1 - 7 of 7 Posts
Top