Honda CBR 600RR Forum banner
Status
Not open for further replies.
1 - 12 of 12 Posts

·
Registered
Joined
·
2,023 Posts
Discussion Starter · #1 ·
Both units have about 7000 miles on them.

This is the Stainless Steel Race Exhaust. Comes with removable baffle, carbon fiber tipped muffler, carbon fiber hanging bracket for the undertail, header bolts, and connecting springs.

The PC III has been tuned for this exhaust and a high-flow filter (filter not included). I prefer to sell as a unit, since the PC III works with this pipe.

The last picture shows a spot on the side of the pipe that would sit above the right side rear-set. This is usually covered by the exhaust cover, but I ran mine without one.

I'm asking $1100 shipped for the whole kit.

Here are some pictures:













 

·
Registered
Joined
·
2,023 Posts
Discussion Starter · #5 ·
Thanks guys. Of all the mods I did to my bike, I think the Akra was my favorite. It really has a beautiful growl.

Plus, getting rid of that hideous cat and stock muffler was a huge bonus...not to mention the power gains up top. Combined with a -1/+2 setup, this bike came out of corners WAY better than other 600s. You could leave a 636 in the dust...
 
1 - 12 of 12 Posts
Status
Not open for further replies.
Top