Honda CBR 600RR Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2,388 Posts
Discussion Starter #1 (Edited)
I just fit my e-racing fairings. I tried to start it during my e-racing install and it wouldn't till i remember the BAs connector plug wasn't plugger in, I plugged it in, it started then I unplugged it to finish the install. I fit them then took them all off to start putting the bike back together. I plugged everything in then when I go to putting my mids on then turned the key to make sure my signlas were working and I hear the fuel pump prime. So I tried to start it and it wouldn't. The gauge cluster works its just the bike wont start. I checked fuses and they were fine, I don't know what else to try. I didn't touch the BAS sensor so I don't think thats the problem. Please help!

I dunno if this matters but I'm low on fuel (Flashing), and its on the rear stand. You think that could be the problem?

This in on my 08 600rr
 

·
Registered
Joined
·
2,388 Posts
Discussion Starter #2
OMG I am a total retard. Problem solved people. Turns out my stop engine switch was on...man do I feel dumd. Thanks all who witnessed this sad even. Yes i am retarded...that it all....*sigh*
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top