Honda CBR 600RR Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
464 Posts
Discussion Starter #1
Hey Guys, i'm trying to fix my bike back up after a spill in april at the track that put me out till now(broke tib and fib in left leg).

I finally got around to start to fix the bike.

I've been looking for the 'swivel' screw that connects to the shift rod but with no luck.
Anyone know where i can get it?
I looked at OEM parts but it doesn't have a part number. It's also not one of the replacement parts available on the woodcraft site.

I have an 03 600rr and i have the woodcraft CFM rearsets.

I'll post up a pic of what i need to replace.

Thanks!!
 

·
Registered
Joined
·
8,768 Posts

·
Registered
Joined
·
8,768 Posts

·
Registered
Joined
·
254 Posts
Go HERE:
http://www.mcmaster.com/#rod-ends/=8js0za

Select "ball joint rod ends" (second option), then select
-High strength (first option)
-Male shank
-Right or left hand thread (I doubt it's left)

Then your threads are either M6x1 or M8x1.25
These two will either have a 6 or 8mm diameter hole respectively, which should work for you.
The item #s for those are 59935K82 or 59935K83

You can bulk up on any other stuff you need here too.
An alternative route is getting a "Ball Joint Linkage" type rod end, which already has the stud sticking out of it on both sides.
McMaster RULES.
 

·
Registered
Joined
·
464 Posts
Discussion Starter #8
thanks!! that was very helpful for the future man!!

btw i ordered some replacement parts from woodcraft for the rearsets and asked them about it. They threw one in for $12 :)
 
1 - 8 of 8 Posts
Top