Honda CBR 600RR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I just pick up a 2006 600RR from insurance auction. Every thing is fine with the bike but one thing keeps on bothering me . It has clear alternatives tail light and front hot bodies turn signals. Now who ever try to install the clear alternatives did a terrible job and after cutting the stock and clear alternative connectors just gave up. Now it's my turn to hook up the wires. When the fuse is blown i get brake light but no running lights, if i put in a new fuse(10A) than i have no lights at all. I get a reading of -11.98 on the brake light and nothing on the running lights. If the fuse blows than i get a reading of +11.something and brake light works but it seems like i'm not getting the power from the running lights. This thing is slowly pissing me off lol
Any ideas guys??
thanx
 

·
Registered
Joined
·
190 Posts
Sounds like you're grounding out your running light maybe? Try tracing back the stock wiring for the running light and check to make sure its not grounded prematurely or just open.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
thanx for the reply. I figure it out today after checking out clear alternative website and my buddies 600rr. previous owner(idiot) cut the plugs and left it like this . Now i was hooking it up color to color so black to black green to green and green yellow to red( i checked with multimeter which wires have power and which is ground on the bikes harness). Now Clear alternatives somehow uses a different color code and it hooks up black wire from the tail to green wire from the bike's harness and black wire (ground) from bikes harness to green yellow(i think) from the tail light and than the red tail wire to green bikes harness wire. lol really confusing if you read it but simple when you look at it on the bike. Now all i need is 2 resistors for the turn signals and off to get a safety ;)
 
1 - 3 of 3 Posts
Top