Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Banned
Joined
·
544 Posts
Discussion Starter #1 (Edited)
Ok guys, I took the clutch cover off yesterday to paint it High temp black(looks nice) and now once I got it back installed, the bike won't shift- I can't start it(still not that far along on the rebuild) but anyone know why it won't now? I think I got that clutch pin installed right, clutch lever works like its supposed to. I put the 2 washers back when they fell out. Any help would be great, thanks in advance.

Steve

Edit- problem gone- all I needed to do was spin the front sprocket a little and it shifted fine, man, I gotta get this bike to where I can fire her up.
 

·
Overpaid South Pacific Barista overactive ADHD c
Joined
·
27,367 Posts
you must have been freaking!!!! nice problem solveing..
 

·
Registered
Joined
·
240 Posts

·
Banned
Joined
·
544 Posts
Discussion Starter #4
All I ended up doing was taking the cover back off( mess with gasket maker on it) and making sure that the lever would end up in the right position once I got done wiggling it. If its right, it should just about pull the clutch cover on to the case. Hope this helps- Post up in your thread if it doesn't and we'll go from there.
 
1 - 4 of 4 Posts
Top