Honda CBR 600RR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
166 Posts
Discussion Starter #1
We did the clutch, replaced it with barnett, and the installaion went fairly well with no major hiccups. Now it won't start, I read all the threads about people taking off clutch cover and it not starting after they did that. Now the bike won't start on it's own, we can push start it and it runs fine, it'll cycle through all the gears, but the we turn it off, and try to start again, and it sounds like it's about to go, and then something stops it, it stops and that's it. Fuel pump primes and everything, all the good stuff. The only thing I can think of maybe is hat we tightened the clutch springs to tight? but I used a torque wrench and it cycles through all the gears, so I dunno... any suggestions..?
 

·
Registered
Joined
·
166 Posts
Discussion Starter #2
Nevermind, got it, I misplaced one of the washers, and I loosened the springs a little bit.
 
1 - 2 of 2 Posts
Top