Honda CBR 600RR Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,266 Posts
Discussion Starter · #1 ·
When I pull in my clutch, the lever doesnt completely return to its resting state. Instead, it hangs about a half inch back. I dont know if I just need to tighten the cable though. When looking down at the clutch lever on the motor cover, the mechanism itself might be the issue. In the pic, the lever is where it sits after pulling it in, and the red line is where it would be fully returned. Is it possible that the spring under that part has somehow weakened?

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top