Honda CBR 600RR Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
238 Posts
Discussion Starter #1
Ok, I just had the front clip off the bike to wire in some led mirrors and install my HID kit. I also deciced to wire in a new flasher relay to avoid resistors everywhere. Everything works fine on the left side of the bike, all blinkers work, and have a normal flash rate. The right side of the bike is a different story. All the signals on this side (mirrors, flushies, and trip's pass peg signals) are dimmly lit. Very dim. If i use the signal for that side it blows the fuse. So what should I be looking for when i t ear everything back apart?
 

·
Registered
Joined
·
1,187 Posts
Sounds like a short to ground. Make sure you have your +/- leads correctly wired and not swapped.
 

·
Registered
Joined
·
238 Posts
Discussion Starter #3
I hope thats all it is.
 

·
Registered
Joined
·
238 Posts
Discussion Starter #4
?????????????????? anyone else???
 

·
Premium Member
Joined
·
14,330 Posts
Something on the right side is grounded or has a short... Double check all the wires and connections...
 
1 - 5 of 5 Posts
Top