Honda CBR 600RR Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
457 Posts
Discussion Starter #1 (Edited)
what does the yellow and white wire connect to?

 

·
Registered
Joined
·
457 Posts
Discussion Starter #2
:bump::bump::bump::bump::bump::bump:


Anyone ?
 

·
Registered
Joined
·
457 Posts
Discussion Starter #3 (Edited)
---cam pulse generator ?
 

·
Registered
Joined
·
1,331 Posts
Does it have a red connector on it? In the service manual its showing the wire going into the case using the rubber grommet to seal the clutch cover. if it is that, it is for the crankshaft position sensor.
 

·
Registered
Joined
·
457 Posts
Discussion Starter #5
I'm not sure about the red connector, but the wire does go into the case using the rubber grommet to seal the clutch cover.
if it is a crankshaft position sensor, it got damaged. I just got a service manual(my new bible), so i can look into it further and see if that is it.

are there any vendors on dotnet that can give me a good price for a replacement?
 

·
Registered
Joined
·
457 Posts
Discussion Starter #7
Yep, crankshaft position sensor.

I have a good one from an '06 motor if you're interested.
YES I am interested, thats what year my engine is 06, - how much?

I know that 03 to 06 the RR are really close, but what years should i look for on direct engine parts replacements? ( 05 to 06 )
 

·
Registered
Joined
·
457 Posts
Discussion Starter #9
do you need to reset anything when changing the crankshaft position sensor?
 

·
Registered
Joined
·
457 Posts
Discussion Starter #11
thanks,
that's what i have been reading.
so far it looks like the only thing is to make sure to put it in correctly.
 
1 - 11 of 11 Posts
Top