Honda CBR 600RR Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
874 Posts
Discussion Starter · #1 ·
Stupid me lost a PM I had from a member on here talking about how to work with fiberglass to make molds. If you are still out there, or if there are other gurus looking at this....chime in. Thanks
 

·
Registered
Joined
·
1,970 Posts

·
Registered
Joined
·
5,131 Posts
I think that was me. What do you want to know?
 

·
Registered
Joined
·
874 Posts
Discussion Starter · #4 ·
USMC..you sent me a great write up or a PM telling me basically how to make a mold and whatever I wanted......I want to mess around with it over the winter....what do you still have??
I remember aluminum foil being involved if that helps any.
 

·
Registered
Joined
·
5,131 Posts
i wrote that up myself and you lost it! I wrote it just for you! anyway...the web can help a lot. read some writeups and if you have any questions hit me up.

My next little project is making a race tail from a spare stocker i got for $20. Gonna glass a cowl directly onto it and glass over the taillight hole.

anyone know how race tails attach other than those front 2 bolts?
 

·
Registered
Joined
·
1,970 Posts
How well will fiberglass stand up to the heat of the exhaust? I was going to epoxy a junked tail light lens on mine but if glass will stand up i'd rather do that.
 

·
Registered
Joined
·
5,131 Posts
most fiberglass bodywork i have seen in close proximity to exhaust is heat shielded. It may break down the resin over time.
 
1 - 7 of 7 Posts
Top