[bastiz_mars]

Hi I tried to search a writeup of a 2004 frame sliders installation instructions. Can you help me. thanks in advance.

 

[101stABN]

Try this....
http://sportbikeguy.com/garage/floor/frameslider.html
or this...
http://www.600rr.net/vb/showthread.php?t=30551&highlight=frame+slider+install

Best way is to line it up with a laser pointer though, i did mine that way, it is as perfect as can be.

 

[bastiz_mars]

will I really need to have a jack for my motor? and what is that aluminium spacer

 

[101stABN]

Jack for your motor? It will be easier if you have at least a rear stand (swingarm). There is a stock spacer between your engine and the bolt housing on one side of your bike.

 

[bastiz_mars]

But my right frame slider is not like this one it is the same thant the left one.
Will I need to remove the stock spacer? and is there different kind of hole saw because I go to home depot and they all have big teeth. will it do a great job because the hole saw that i bought was for wood.

 

[Black05rr]

I did mine without having to use a jack. Just take out one engine bolt and replace it with the slider bolt, then do the other side.

I wouldn't use a wood holesaw as the teeth are alot more coarse then they are on a bi-metal, or metal bit. It might chip or crack the plastic if you cut too fast, you could probably make it work but I wouldn't chance it.

http://www.600rr.net/vb/showthread.php?t=30462&highlight=frame+slider+step

 

[bastiz_mars]

where did you get a smaller teeth saw?

 

[MeltdOwn350]

use the hole saw for wood, just run it in reverse

it doesn't tear up your plastic that way but will still cut just fine

 

[bastiz_mars]

are you sure?