Honda CBR 600RR Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter #1
Hi
Can you guys recommend a set of frame sliders/crash bungs for an 03 that doesn’t need the fairing to be cut/drilled,I can’t seem to find any!
Thanks
 

·
Registered
Joined
·
966 Posts
That's because no cut sliders are total crap
 

·
Registered
Joined
·
44 Posts
I bought no cut ones for my 05. They don't even fit. I wouldn't waste my time with them. Waste of money.

Also, I dropped mine in a parking lot going about 10km/h. Wet leaves, front tire slid sideways.. anyways. My bar ends were the only thing damaged. If you're worried about low speed or stopped drops, I don't really find them worth it.

Bar ends
Shorty levers
Rear axle spools for the stand is all you need IMO
 

·
Registered
Joined
·
75 Posts
No cut sliders work off an extended bracket.

In a heavy fall/impact,this bracket can actually bend back into the side of the engine and crack the cylinder head.

I would avoid installing them and just use the normal ones that need a hole saw to be used on the fairings.
 
1 - 5 of 5 Posts
Top