Honda CBR 600RR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,232 Posts
Discussion Starter #1
I have a remote dual zone controller for my heated gear, which consists of gloves, pants, jacket, and socks (all liners). The way it's wired up stock is so the gloves are in one zone, everything else in the other. How do I wire it so the jacket is in one zone, and everything else is in the other?

Sent from Motorcycle.com App
 

·
Registered
Joined
·
1,232 Posts
Discussion Starter #2
I have a remote dual zone controller for my heated gear, which consists of gloves, pants, jacket, and socks (all liners). The way it's wired up stock is so the gloves are in one zone, everything else in the other. How do I wire it so the jacket is in one zone, and everything else is in the other?

Sent from Motorcycle.com App
Adding a response in case anyone ends up searching for this thread in the future.

I was able to figure this out. I needed a DC splitter, which the pants came with. Out of the box, the splitter joins the pants and socks so only one connection needs to be made from jacket to pants. To wire it up so the gloves and socks are on one circuit, the splitter needs to be on the connection inside the jacket to go to the male glove plug - that's the one marked "to gloves." The male end of the splitter goes to one of the female ends of the controller, and the other male end goes to the pants. In the pants, the black male is socks, the red male end is pants. That means now I have to make 2 connections from pants to jacket when I wear all the liners, but now one control is for jacket and pants, one is for gloves and socks, which is a better set up for me.

Sent from Motorcycle.com App
 
1 - 2 of 2 Posts
Top