Honda CBR 600RR Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
68 Posts
You shouldn't need a gasket; there wasn't one from the factory. Hondabond should be fine. Otherwise agreed on replacement. The big difference with Hondabond or RTV is that you're going to tighten to finger-tight, wait a while (directions should be on the packaging), then tighten per step 6, above.

I'm not sure if you should use Hondabomd/RTV around the rubber grommet. Directions say no, but I get a small amount of oil seepage from there.
 
1 - 1 of 1 Posts
Top