Honda CBR 600RR Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
378 Posts
Discussion Starter #1
About a week or so ago, I got the the '04 RR ready for installation of some Factory Pro velocity stacks by removing the stock ones. The bike was apart until this evening when I finally had a chance to install them tonight, but I soon realized that I had a connector that wasn't plugged into anything as started reinstalling everything. I guess I must have forgotten in the past 10 days or so, or simply didn't pay attention?

For what it's worth, I have a PC3 installed. Perhaps the PC3 installation resulted in this plug being unplugged? I installed the PC3 about a year and half ago so I simply don't remember much.

Any thoughts?

 

·
Registered
Joined
·
378 Posts
Discussion Starter #5
Downforce137 said:
Nevermind... looked again, I thought that pic was the left side of bike.. Its not the rear brake light switch?
You know what? I think it is indeed the rear brake light switch. I know when I installed the Sato rear sets, I opted not to install the rear brake light switch.

That has to be it! Thanks!
 

·
Registered
Joined
·
378 Posts
Discussion Starter #7
Downforce137 said:
:) glad i could help.. I prolly wouldnt know that much, but.... http://www.600rr.net/vb/showthread.php?t=48387
Ah! :)

All of the mods on the '04 were done within 2 months after picking it up in 08/04 and the '05 is essentially stock so it's been quite some time since I've done any real work on the bike aside from oil changes and prepping it before each track day.

Thanks again!
 
1 - 7 of 7 Posts
Top