Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
2010 engine blew at the track last weekend and I'm trying to drop it out now.
Are there any type of write ups or tips here that may help?
 

·
Registered
Joined
·
389 Posts
Pretty much just remove everything surrounding/bolted to the engine. Then, if it's anything like my f2, you can support the engine from underneath with a jack and just let her down with the help of a friend.

My tip would be to buy the clymers manual. The one I had for my f2 was awesome.
 

·
Registered
Joined
·
87 Posts
I replaced the motor in my '07 about 6 months ago. I just followed the steps in the service manual, I'm sure there's a copy floating around on the forum somewhere.

You'll need a jack to drop the motor (bring a friend for that part too), as well as a special socket for removing the castle nuts on the frame bolts. I bought the one in the link below, the exact one is unavailable but there should be similar ones on amazon.

https://www.amazon.com/gp/product/B019T7C4FS/ref=oh_aui_detailpage_o07_s00?ie=UTF8&psc=1

Good luck! Post up if you run into any snags.
 
1 - 4 of 4 Posts
Top