It looks like the rings came apart? WTH?!
Is it reusable?
deep 0.07inch~0.1 inch i guess.............
I don't know why, but the piston broke and the pieces dug up the wall.
ugh... danoxyz.. thats why....
1 - 8 of 8 Posts
i dunno, surely previous owner lmao
I decided to work on the cylinder sleeve.
I'll reveal the before and after later.
D
I just went through this, melted a hole in a piston and scored the cylinder wall...i dunno, surely previous owner lmao
I decided to work on the cylinder sleeve.
I'll reveal the before and after later.
My original plan was to hone the cylinder smooth or bore it .5 over and get a 67.5mm piston...
But then I found out about these coated cylinder walls and realized that honing or boring wasn't really the best option.
I ended up buying a used case ($150) & a used piston ($30) on ebay.
Plus new rod bolts ($55) & a couple gaskets and rebuilt the whole thing for about $400 myself if you have the time and patience 👍
The bottom case is the old one and the 2nd hole from the left was the one I honed before I changed my mind
Wesley S's tear down and rebuild (03-04)
Welp FML... Er, I mean merry Christmas 🌲 everybody... LoL So... I hurt the motor. 🤦 I was out on a sparsely populated 3 lane highway in Mexico last night... I was being extra careful... pinned in 6th gear & it was running great 😀... until it wasn't 😕 oops It did stay running (like ****) I...
www.600rr.net
IIRC, Bad fuel pump/loss of fuel pressure and flow.
1 - 8 of 8 Posts
