Honda CBR 600RR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
392 Posts
Discussion Starter #1
I know this has been going around buy my situation is a little different. I have R6 lights on my bike w/ halo eyes. I was wondering would it be to much wattage for me to run the low beam side to the high beam side. so when the switch is down the lights are off and when I hit the high beam switch it turns on both light. Pretty much I want to run both lights from the high beam wires by taping the low beam side into high beam side. Because I want to be able to use the halo eyes by them selve sometimes. or should I just add a switch to my low beams. and be done.
 

·
Please Excuse me, I've been drinking again.
Joined
·
4,452 Posts
Add a switch to your low beams. It'd probably be easier, and safer...I added one to my light, and it's kick-ass (the switch...the light itself is just ok...it does it's job, and I'm happy about it)
 
1 - 3 of 3 Posts
Top