Honda CBR 600RR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
96 Posts
Discussion Starter #1
I recently attempted to install LP short stalk front signals using dual filament no splice connector from LP for Honda (part 122-9651) and found out the damn thing doesn't fit the oem female connector on the bike?? anyone know about this?? was looking on LP's website (http://www.lockhartphillipsusa.com/rs/showProduct.cgi?prodID=2094) for connectors and noticed they have ones specified for Honda then further down ones specified for the 600rr specifically?? i'm kinda pissed now cuz i also ordered single filaments for the rear (part 122-9650). someone help??
 

·
Registered
Joined
·
1,280 Posts
Honda 600RR 03-06 Single Filament 12296514
Honda 600RR 03-06 Dual Filament 12296515

Yeah these are the part numbers you want. I end up doing what Ichiro said and just cut off the stock harness from my OEM front signals and soldered them onto my Hotbodies. My left front OEM signal was wrecked anyhow from a crash.
 
1 - 3 of 3 Posts
Top