Honda CBR 600RR Forum banner
Cancel

Melted plastic

601 Views 6 Replies 7 Participants Last post by  Ceph, 
sideout
The plastic piece on the right side next to the exhaust melted onto the mid-pipe. Anyone have ideas on the best way to get that off without trashing the pipe?
THanks
Reply
Save
Like
1 - 1 of 7 Posts
H
i was going to suggest the same as nuclearr just besure to take of any fairings near where you are working so you don't melt those too. should be able to heat it up and wipe it off. carfull its hot!!!1
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CBR 600RR Forum
A forum community dedicated to Honda CBR 600RR owners and enthusiasts. Come join the discussion about performance, engine modifications, troubleshooting, exhaust kits, and more!
Full Forum Listing
Explore Our Forums
General Discussion 03-06 RR Modifications 07-12 RR Modifications New Members Troubleshooting
Top