Honda CBR 600RR Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2,061 Posts
Discussion Starter #1
Hey guys

I'm replacing the cylinder head gasket on an 08RR that has a stripped head bolt hole. I know I have to use a time-sert (heli-coils won't hold torque, I know this because the previous owner put one in there, that's why I'm replacing it again.) I just need to know which kit to get. I don't have the motor apart just yet. Was hoping one of you could help or had any previous experience with this before I break it apart. Any help is much appreciated.

Bolt #12. Listed as 9x90.
http://www.bikebandit.com/oem-parts/2008-honda-cbr600rr/o/m17500#sch558657

Here are the Time-Sert metric kits.
http://www.timesert.com/html/mtrcsert.html

Worst case, I'll break it apart and do a quick measurement.
 
1 - 1 of 1 Posts
Top