Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I recently laid my bike down and broke off both OEM front turn signals, now after I fixed the bike back up my flush mounts wont even flash. I double checked the wiring and its right any other ideas to what is the problem?
 

·
Premium Member
Joined
·
13,137 Posts
You need either an LED relay or load resistors if none of them flash (front and rear), otherwise you have wired something incorrectly.

What year is your bike?
 

·
Premium Member
Joined
·
13,137 Posts
In that case you have more than likely wired it up wrong...

There are three wires going to each signal (assuming you are in the states) which ones have you wired up to?
 
1 - 4 of 4 Posts
Top