Honda CBR 600RR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,388 Posts
Discussion Starter #1 (Edited)
So I finally got around to putting together my street bike. I did a few part swaps from my street bike to the race bike before I finally got it out. I only swapped the arrow full exhaust and pc3. I reinstalled the stock exhaust in my street bike and thats pretty much it. Now i just went for a ride and the bike has no power...like it doesn't want to rev over 9000 rpm and accelerates like a scooter... No FI light...

The only thing I can think of is I wired the exhaust servo in backwards....but I cant see that causing that much power loss...I dunno.

Any help?
 

·
Registered
Joined
·
2,120 Posts
The only thing I can think of is I wired the exhaust servo in backwards....but I cant see that causing that much power loss...I dunno.


That would cause a huge power loss if the flap was closed at higher RPMs. Sounds like a good thing to check.
 
1 - 3 of 3 Posts
Top