Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Hi, long time lurker, first time poster.

I have a 2004 CBR600RR, It's a Euro spec with 2 o2 sensors. I've Tried getting the eliminator plugs from ebay with no luck. The MIL light still comes on, error code 23 and 24.

Next I tried just bridging it with a piece of metal, same again.

Third I tried putting a 330 resistor in there and i'm still getting the MIL light, FI on dash and error codes 23 and 24.

I've reset the memory on the ECU. (bridged the green and brown wires on the red plug then turned the bike on then removed and put it back on until the MIL light flashes indefinitely)

Am I missing something here? I was under the impression adding a 330ohm resistor to the plug was supposed to stop the MIL light from coming on?
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3
I'll make sure but I'm pretty positive I've got it on the white wires. I'll post back when I've had a check, thanks
 
1 - 4 of 4 Posts
Top