[Skunkwurk]

Hi Fellas,

I recently performed a thorough maintenance to my, new to me, 09 600rr. Refreshed the oil, coolant, brake fluid, air filter, and plugs. When I removed the lower fairings I had 2 pieces fall to the ground, see pic. I spent quite a bit of time looking to see where they might have come loose from but I was not able to spot it. In any case, I am posting here to see if any of you have seen this little bracket on your bike. It is shaped a certain way as part of the cable management.

It is an ABS bike, so it has additional wiring, hoses and lines for the C-ABS system. Anyway, any help would be appreciated and thanks in advance.

 

[NewRedRider]

Welcome to .net!

I think you're correct in thinking it's a cable tie for the wiring harness. Where it came from is anyone's guess.

 

[toRRa]

Check if it's the cable holder close to the gear lever / side stand wires.

 

[Skunkwurk]

Thanks, fellas. I checked and was not able to spot where it came from. toRRa, I checked the gear lever / side stand wire and that one is in place - very odd.

 

[dannoxyz]

Did you go to any bike meets lately?

 

[NewRedRider]

The PO may have lost it at one time and didn't think the check the lower fairing. He may have gone and replaced it and now you've found the original part. That my be why you can't find the missing place it came from. It's already been replaced.

 

[Skunkwurk]

The PO may have lost it at one time and didn't think the check the lower fairing. He may have gone and replaced it and now you've found the original part. That my be why you can't find the missing place it came from. It's already been replaced.

Yep - I agree.

Thanks, fellas.

 

[_Bus1_]

Looks like it could be from whats used to hold the fuel/vapor lines in place. My best guess is it's the one on the bottom of the fuel tank (not pictured), or its possible to be the one like in the picture.

 

[Skunkwurk]

Looks like it could be from whats used to hold the fuel/vapor lines in place. My best guess is it's the one on the bottom of the fuel tank (not pictured), or its possible to be the one like in the picture.


View attachment 228842

That one kind of looks like it is shaped the same. I'll definitely check for that one.

Thanks!

 

[tary preisser]

Bus 1 is correct. it's 1 of 2(?) hose routing clamps that are drip/vent hoses that vent down by kickstand.