Honda CBR 600RR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
652 Posts
Discussion Starter #1
So recently had my rims powder coated and the powder coater did not mask of the area where the wheel bearings seat. Wheel bearings were removed for the sand blasting process. Has anyone experienced an issue like this before? My concern is that the bearings will not seat fully or correctly. Thoughts?
 

·
Vendor
Joined
·
14,330 Posts
Did you put the bearings back in yet? Probably going to need to clean out before installing or they aren't going to go in correctly.
 
1 - 3 of 3 Posts
Top