Honda CBR 600RR Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
668 Posts
Discussion Starter #1
What would cause a turn signal light to go solid? I hope this makes sense. I'll explain my right turn signal goes solid when activated. My left is fine. I know is cars it can be as simple as a bulb replacement. Is it the same as bikes? I have an 05 btw with clear alternatives and flush mounts, neither work (solid, not blinking) on the right-side from the cluster all the way to the rear.

Thanks in advance!
 
K

·
Guest
Joined
·
0 Posts
then i'd check the wiring. all of it. after that you MAY wish to isolate the Turn Signal relay, or replace it altogether. i'd take a volt meter to the relay to see if it's sending pulse voltage. it could very well be that the (unserviceable) relay in the dash is broken.
 

·
Registered
Joined
·
668 Posts
Discussion Starter #8
I've ordered the relay as Moe suggested haven't had time to install it. However my right turn signal started working again, crazy. In order to make it work I have to activate the left first then right works like a champ. I'll replace the relay.

But my question is, is it something else I need to look at?
 
1 - 8 of 8 Posts
Top