Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I was attempting to do rear brake pad replacement, for some reason the caliper would not move far enough away from the bike and would keep touching the rotor with new pads so I couldnt install them. Tried to take off the bolt with the allen head in order to remove the whole thing but it was so tight I stripped the allen head. After I get it out does anyone know the part number? Honda parts diagram strangely doesnt label it.
 

·
Registered
Joined
·
424 Posts
Before drilling it, welding an Allen wrench to the stripped bolt might be the easiest way to go.
 
1 - 4 of 4 Posts
Top