Honda CBR 600RR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
I need help finding the right tools to work on my bike. I have a 2014 CBR600RR that I am rebuilding. I have just put the engine back into the rolling chassis, and I want to torque down a few key spots before I go any further. There are 2 20mm engine mounts, a 24mm swing-arm attachment, and the triple tree. (28mm+ I am unsure of the exact measurement) I have purchased a $10 20mm spanner-nut socket off amazon. I am looking for a better alternative since this style has a habit of slipping off when applying any real torque. Any help would be much appreciated. I will leave a link to a kit I found on amazon below. The style that I am looking for is in the top right hand corner of the imageappvalley tutuapp tweakbox
 

·
Registered
Joined
·
1,205 Posts
The rear wheel takes a 32mm socket. I have used the Bikemaster spanner wrench to adjust my rear shock without issue. I just use a 1" 18" steel pipe for leverage. It fits around the end of the spanner wrench fine.
 
1 - 2 of 2 Posts
Top