Honda CBR 600RR Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
310 Posts
Discussion Starter #1
I have taken off my entire midpipe and the cancan and also attempted to beat the can off with a rubber mallet, as well as trying to twist the can off. I was able to get the can to twist a little bit, but not even near a full 180 degrees. The reason i want to get the can off is so that i can make a shorty exhaust, but I just cannot get the exhaust can off. Any ideas? I don't want to beat the can too hard and dent it up. Thanks for the help guys!
 

·
Registered
Joined
·
7,442 Posts
it's probably corroded onto the midpipe. Spray some penetrating oil on it and let it sit for a while and try again
 

·
Registered
Joined
·
310 Posts
Discussion Starter #5
That was my best guess. It is a 2005 and the exhaust has been on since 07 so that is probably it. I'll let you know how that goes!
 
1 - 6 of 6 Posts
Top