Honda CBR 600RR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi there Gentlemen. 03/600 CBR-RR



I am in charge of doing the electrical section on the race car and I was hope to get some tips on what things I may be able to disconnect and not run into any drivability problems or starting problems?



I have all the sensors on the engine and trany. and the wiring harness that comes off the engine.



I don’t have the dash, engine stop start sw, clutch sw, side stand sw, clutch sw, and neutral sw.

I have heard that the head lights being out of the loop may cause probles also? True or False.


I was hoping there maybe some short cuts that would help me out.



Thanks for your help Gentlemen.

CJ
 

·
Registered
Joined
·
300 Posts
Hmm, I can check my car when I stop by sometime next week but off the top of my head you can get rid of the following

-bank angle sensor
-all lights
-turn indicators
-fuel sensor (just use a sightglass in the tank)
-engine start (leave the killswitch though, comes in handy for saftey reasons)
 
1 - 2 of 2 Posts
Top