Honda CBR 600RR Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
6,502 Posts
Just buy a pressure switch and you'll keep your brake lights. You do the same when installing a Master Cylinder.
 

·
Registered
Joined
·
147 Posts
Or dont slice it u pand unclip it at the harness like i did..when you sell it put the stockers back on. How often do you brake without the fronts anyways...
 

·
Registered
Joined
·
9,216 Posts
Or dont slice it u pand unclip it at the harness like i did..when you sell it put the stockers back on. How often do you brake without the fronts anyways...

+1^
the sensor has a plug that attaches it to the wire harness, just like every other electronic component.
 

·
Registered
Joined
·
568 Posts
Discussion Starter #6
I don't brake without the front at all. The only time I use the rear brakes is while sitting on a traffic light and flashing the brake light for cagers coming from behind.
Or dont slice it u pand unclip it at the harness like i did..when you sell it put the stockers back on. How often do you brake without the fronts anyways...
Do you have any pictures for this.... I will really like to do it in this way.
 

·
Registered
Joined
·
9,216 Posts
just trace the wire from the brake lever.
i seem to remember the plug is right around where the subframe meets the gas tank under the black textured side panel.
 
1 - 8 of 8 Posts
Top