Honda CBR 600RR Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
Hi Guys,

During this winter I want to build a street fighter of my (crashed) '05 600RR.

I have to admit that I don't want to change handle bar to straight ones like typical street fighters have.

Here comes up a problem with mirrors. Probably I will buy these:
http://www.oberon-performance.co.uk/acatalog/Bar_End_Mirrors.html

but can you help me, what handle bar hole diameter should I pick? (see the bottom pic on that page)

Or maybe you have a better idea which mirrors would be ok in my situation?
 

·
Registered
Joined
·
13,229 Posts
off hand i'm not sure the ID of the clip-ons. best bet is just to take your bare end off and measure. your bike has the weights inside the clip-on and the bar end bolts to that. so you'll prolly only end up using the bare end and mirror itself, none of their internal parts. bar end mirrors are gonna vibrate bad, their merely there because you have to run mirrors, and that's about it.
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #5 ·
After reconsidering bar end mirrors solutions I agree that it will vibrate too much.

This complicates my position a little, because there are no many possible places to mount mirrors in my bike :/
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #7 ·
I was gonna say "No luck in the stunt section"?
Nope, crash on a race track. Just decided to build a streefighter instead of investing money in new fairings.

I know it may sound lame to some of you, but in this way I will make a bike which I won't be affraid to play with a little bit harder than "shiny" toy.

And look how brilliant solution F_iT23 did :) Just the simpler, the better.
http://www.600rr.net/vb/showpost.php?p=1932377&postcount=10
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top