Honda CBR 600RR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
507 Posts
Discussion Starter #1
hey all..i just took my swingarm off to get powdercoated and i knocked the needle bearings out..is anyone here replacing these after knocking them out, or are you just taking them out carefully and re-using them?
 

·
Registered
Joined
·
507 Posts
Discussion Starter #3
well i have a press at my work to do it..i just wasn't sure if everyone who removed their swingarm was replacing these bearings..i took them out carefully and nothing at all is wrong with them..i popped the seals out without damaging them..or the bearings, i just wasn't sure if i should go ahead and just replace them if they're fine
 

·
Registered
Joined
·
336 Posts
If it doesn't cost too much new, I would replace the bearings. The last thing you want is to put everything back together and find out the bearing is no good.
 
1 - 4 of 4 Posts
Top