Honda CBR 600RR Forum banner

Swingarm

1K views 8 replies 8 participants last post by  Rad Rage 
#1 ·
Here is a picture of one side of my swingarm. The other side is fine. Before I commit to my bike (and start modding) do you think this will be an issue at any point (resale value, technical perspective etc.) Is a repair possible? I already have to buy axle block sliders instead of standard sliders because as you can see the mounting point on the swingarm is disfigured.


20121130_154427 by SurgeRR, on Flickr
 
See less See more
1
#5 ·
Just weld a new 8mm boss on there.
Yes, it will effect your resale value, of course. You can probably find a used swingarm on Ebay, if, and when you decide to sell it.
 
#7 ·
hmm, i say youll be fine. you just wont be able to install rear spools no more. and will have to find another way to lift your bike up when needed..
worse case... buy a new swingarm and swap them out..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top