Honda CBR 600RR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Hey gang, I'm back looking for more help. You guys are always right on point and quick... victims of your own success you are.

Here's my problem, I have an 06 CA integrated light on an 07 and the DTRL are constantly on ( the light just stays yellow). When I hit the signal, it flashes between Red and Yellow but that's the ONLY time the light actually shows red. Not even when I hit the brakes do the red LEDs light up... this is bad.

I've read just about every post I could find on this install and not too many people have anything to say about it at all.

I have a wiring diagram so if you know wire color codes, you can use them and I'm pretty savy. However, this thing has me stumped big time.

Thanks gang:wave:
 

·
Registered
Joined
·
11 Posts
Discussion Starter #2
Figured it all out on my own :book1:

It was the front O/W and LB/W wires for the DRL. I just cut them, sealed the ends with a spot of shrink tape and presto', working brake lights and turn signals in the rear.
 
1 - 2 of 2 Posts
Top