Honda CBR 600RR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
207 Posts
Discussion Starter #1
I am reassembling my bike because I took the upper off to put on blinkers and took the tank off to dynomat it. Well I put the upper back on and the tank and I noticed that my throttle was acting funny. When the handlebars are straint or turned to the left, you can fully open the throttle and when you let it go it snaps shut like normal. But if the handlebars are turned to the right, when you open the throttle and let it go it stays in place. To close the throttle you have to push it forward with your hand. I never noticed this before. Anybody have any ideas on whats going on?

P.S.
I also unbolted the tank and had it leaning forward a little to get the black plastic that is under the tail off. Could this have affected the throttle cable at all?

thanks
 

·
Registered
Joined
·
176 Posts
The cables may be pinched where they exit the frame (right side of steering head).
Thats the only place I can think of.
 
1 - 3 of 3 Posts
Top