Honda CBR 600RR Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
561 Posts
Discussion Starter #1
I did a search and couldnt find what I was looking for.

Anyhow I highsided my bike last night where is the tipover swicth located, and what need to be done to bypass it ??
 

·
Resident Leg-Humper Females Beware
Joined
·
6,874 Posts
switch is on the headilght housing. have to remove the upper cowling to get to it. bolted between the lights. no clue on bypassing.
 

·
Registered
Joined
·
1,224 Posts
Try to search bank angle sensor. You should find what your looking for. You shouldn't need to bypass it though. Sorry for being to lazy to link to a good thread.
 

·
Premium Member
Joined
·
14,330 Posts
Connect the green wire and the red with white tracer wire.... Later. T
 
H

·
Guest
Joined
·
0 Posts
i think to bypass it you just need to attach the two together that are going into the unit...

jsut curious, why are you trying to bypass the sensor...
 

·
Registered
Joined
·
605 Posts
homerjay4242 said:
jsut curious, why are you trying to bypass the sensor...
I agree, its there for a reason.......To stop your engine blowing up or being damaged anyway but more importantly if the bike falls and you are underneath it the rear wheel and chain wont make mince meat out ya legs !!
 
1 - 7 of 7 Posts
Top